I need one place to buy bolts I need for my 67 project. I have found all of them but the shipping is killing me for seperate orders. I want a place to get them all/ I went by my local GM PartS but the guy was a jerk and you could tell he did not want to fool with looking them up.

I need the bolts for 350 engine 2 long mount mount bolts, nuts
350engine 350 trans auto flywheel bolts
trans to engine bolts for above
torque converter bolts

Have you checked with your local auto parts store?

I went to Advance last night the guy carried me to a isle that had typical bolts in packs. I don't want general cheap grade bolts fo these. I want to use the right grade.

I find Fastenall to be a good source and you can get all grades, you would want GR 8 for the most part. I think ARP has kits that contain all you need and Gardner Westcott has engine stainless and chrome kits. Beware if you buy any stainless fasteners, I thought at one time Stainless Steel was automatically better, not true, there is some soft stuff out there. Buy from a reputable dealer and make sure they certify their product to be equivalent to GR 8 or better. I was a buyer for a company that got burned on this, that’s why I know. I have seen 3/8-16 twist off with less than 30 FT Lb.
.gene68ss

I am in there 2-3 times a week for work, but because I do not know the sizes I need. I f someone could give me these I was be most grateful

Check out AMK Products. They will have everything you need. www.amkproducts.com

You can print charts or order a thread gauge from these folks for under 2 bucks. http://www.boltdepot.com/fastener-information/Printable-Tools/
Or if you are close to Harbor Freight Tools, you can buy thier item #39240 for $1.99 to use to identify any bolts or nuts you need. Good luck
gene68ss

Check out AMK Products. They will have everything you need. www.amkproducts.com (http://www.amkproducts.com)

Mike, thanks parts ordered. After you figure out to use their website they have pretty much any hardware you would need.
Thanks for the link.
Joel

When I did my Elcamino motor I went to Hot Rod shop and bought bolt kit for 350 motor. I also get longer bolts not supplied from local Ace Hardware store. mine has a really big selection of all type's of fastner's.
Jay

I need one place to buy bolts I need for my 67 project. I have found all of them but the shipping is killing me for seperate orders. I want a place to get them all/ I went by my local GM PartS but the guy was a jerk and you could tell he did not want to fool with looking them up.

I need the bolts for 350 engine 2 long mount mount bolts, nuts
350engine 350 trans auto flywheel bolts
trans to engine bolts for above
torque converter bolts

junkyard