Well I finally decided yesterday to get back out working on the car. I went to install the RS mouldings and I must confess...the door section is kicking my a$$. I don't understand how the clips are installed. The door has the 5 holes drilled and I understand the clips with the studs.....but what about the clips that have small screws. I suspect they are for the holes at the very front and rear of the door, but how are the held onto the moulding to get the screws started? I searched through the AIM and couldn't find anything to help me with this. Can anyone help me with this?

Thanks

This may help some....

http://www.hotrod.com/techarticles/body/hrdp_0701_automotive_trim_decals/photo_13.html

Thanks Doug!
I have it pretty much figured out except the end clips are small and I don't understand how they are placed to grab the moulding.......if you were to stop by I can show you what I mean! ;)

See what I can do.