Has anyone or would anyone make available the dimensions or provide a simple schematic of the heater delete plates. It seems to me it would be a lot easier and a whole bunch cheaper to fabricate a set of these then trying to bid for them on Ebay. Has any one seen the complete set of delete plates on Ebay and what they are being bid at? All I need is the firewall plates, just an outlined simple drawing will do.

Thanks Terry

email percep3d@wolfenet.com

------------------

Last set I saw was over $800 dollars!!!!!

There are at $910.00 and the reserve isn't met yet!!!

------------------
...Dennis
Topless'69 (http://home1.gte.net/ddunio/topless69)
Camaros Limited Nor-Cal (http://camaroslimited.com)
rsss.fun@gte.net

Sorry everybody. The question was more of a statement. Actually I've been watching this one and am amazed at what they go for. That's why I am inquiring as to the dimensions, or a simple outline of the plates. I'm sure they can be manufactured much cheaper. I don't need original equipment stuff. I just want it to be a good facsimile. In fact I thought of doing them out of aluminum.

Thanks again,Terry

I hope someone out there can help out!

You could trace around the regular heater box and probably be pretty close. The blower motor plate was separate but I don't know why it would have to be.

The Radio heater delete plate did not sell at over 1200. Clill was the last bidder and maybe oif he buys it he will give you what you need, or at least sell it to you to re-coupe some of his $$

------------------
1969 RS Z28 Black, white deluxe interior,
http://www.corvetteforum.net/c3/corvettj

I believe someone is selling repo firewall pieces. The hard part is the dash piece.

The dash pieces are not that important in my case. I plan on using these areas to house gages. So the firewall plates are all I really need.

Thanks again, Terry

If anyone knows where to get these plates aftermarket, please post?

[This message has been edited by TPI's 69 (edited 09-26-2000).]