The Jan. issue of Super Chevy has a very good article in it on the Tri-5 front suspension conversion being marketed by Jim Meyer Racing Prod's.

It uses an '84 to '92 Buick unit or a Mopar unit. It is placed in the rear steer position so might be of interest for guy's considering the same type of conversion on their first gen. pdq67

i would think it would be a bit on the wide side...i think they said in the article that it had to be cut down for the tri-5...and i think a camaro/nova subframe should be narrower than that. i hear the steeroids kit uses a late model Impala/Monte Carlo rack.and i believe it is unmodified, so it is easier to get a replacement if it goes out in the middle of nowhere.

------------------
1971 Nova(looks like 69 camaro from underneath!)
355sb, vortec heads, HOT cam,T-10 tranny, 3.70 gears 16" IROC wheels

Check out this link....
http://www.speeddirect.com/Products/STEEROIDS/Camaro__67-_69/camaro__67-_69.html



------------------
Joe
WCA Member
HwyStar@Rochester.rr.com
HwyStar@CarJunky.com
'69 wallet crusher
'97 Blazer - Bad wheel hop!