Can somebody give me the measurements of where the hole on the UCA for the brake hose clamp is supposed to be?

I used a 69 set up on the 68, but I just drilled the holes and clamped it kinda in the middle. because I'm trying to be a little more correct with the 69, I was hoping someone can tell me where it was on a factory J52 car. Far as I can find, it is not in the J52 UPC in the manual.

David, if this belongs in "resto" or somewhere else, feel free to move it.

Thanks guys!

Eric is this what you are doing? This is my 69 setup if it helps.

http://www.brainerd.net/~knudsen/69RS/Misc.Stuff/69RSDiscBkDriveSide2a.JPG

Yes, Jim, that's exactly what I am doing. Looks like it's halfway in between the lower and upper bend, for want of a better description. Can you measure from the bottom bend to the center of each of the two holes? A rough straight line measurement would be fine.

Thanks!

Getting 6" of snow right now, trying to keep up with the shovel, so wont get to it right away, besides this pic is from a year ago. car is on the floor where Id have to jack it up for measuring. If anyone else has their car in the air already, maybe they can measure. Which 2 holes are you talking about?
Otherwise I can by the weekend for sure.

Don't worry about it, I will get it close enough based on this pic. Have fun in the snow!

I have a disc brake a arm laying around so I took some pictures for you. If you need a better one let me know.

http://www.gvtc.com/~rlaa/Images/dbarm1.jpg
http://www.gvtc.com/~rlaa/Images/dbarm2.jpg
http://www.gvtc.com/~rlaa/Images/dbarm3.jpg
http://www.gvtc.com/~rlaa/Images/dbarm4.jpg

3" up from the very bottom edge of control arm at the ball joint end. Just happen to have mine out right now. graemlins/waving.gif