|
jvolk81 Jan 29th, 01, 05:41 PM What are the upper and lower ball joints supposed to be torqued to? ------------------ 68 Camaro 396 powerglide 3.73posi Soon to be daily driver Jvolk81@aol.com davidpozzi Jan 29th, 01, 05:46 PM CAMARO SUSPENSION BOLT TORQUES All are in foot pounds-ft Steering gear mounting bolts-70 ft Pitman Shaft Nut 140 ft Steering Wheel nut 35 ft " with tilt 1 ft Steer coupling nut 18 ft Steering coupler clamp bolts 30 ft Tie Rod End nut 35 ft Tie Rod Clamp nut 130 inch lb Ball joint nut upper 50 ft Ball joint nut lower 65 ft Upper ball joint attach bolts (replacement) 25 ft (these replace the rivets holding the upper ball joint to A frame). Steering arm attach nuts 85 ft Lower control arm 85 ft Upper control arm 50 ft Collar bolts 45 ft (bolts that hold the large washer on the ends of the upper control arm shafts) Brake anchor pin (drum) 130 ft Brake andhor bolt (disc) 75 ft Wheel stud (lug) nuts 65 ft [This message has been edited by davidpozzi (edited 01-10-2002).] [This message has been edited by davidpozzi (edited 03-03-2002).] my69gofast Jan 30th, 01, 08:44 PM David Thanks for posting this info. One question, I think the tie rod clamp nut spec might be 130 inch pounds, is that correct? | ||