I want to install a HELLWIG 1.125" front sway bar. But I have read some article that say not to install a rear bar. Should I install a rear bar or not?

David Pozzi has alot of great suspension info on his homepage. http://ourworld.compuserve.com/homepages/David_Pozzi/vintage_transam.htm
I hope thats the right address.

Take a look at a hollow bar from Hotchkis. http://www.hotchkisperformance.com./index.html

It'l save you weight.

When you start getting OVER a 1" solid front bar on a first gen Camaro, you might be getting close to needing a rear bar.

I'd try a front hollow bar if it were me.
David


------------------
Check my web page for suspension info:
David's Homepage (http://ourworld.compuserve.com/homepages/David_Pozzi/)
67 RS 327
69 Camaro Vintage Racer
65 Lola T-70 Can Am Vintage Racer

Will my using aluminum bushings in the back affect the front sway bar size due to less body roll? Will it also make me need a rear one? I also did the gulstrand modification, and going to lower coils one wind.

[This message has been edited by 69er (edited 08-01-2000).]

[This message has been edited by 69er (edited 08-02-2000).]