Does anyone know how to determine if you have an "825"?I have been shopping for headers for my 69 and some say will not fit saginaw 825 steering. Any help???
Thanks
Stan

I am running into the same problem,, manufacture refers to 825 saginaw and from what i found out on the First Gen Suspension people ,, they are referred as to 800 series. You might check it out,, http://www.pozziracing.com
This gentleman may be able to help answer your question but best i got out of it,, hedman should fit, but i read other on this site that they did have to dimple a little? I hate that on coated headers.

here is a pic of the 800 series power steering box.
most of the 800 series look the same but the out put shafts are differnt lenghts.
as far as hedders hedman headers makes a set thats direct fit for your application.
I have an 800 series sterring box and the headers with 3/4 inch of clearance.
But the headers im talking about are the ceramic coated ones.

OK Thanks,I was going to go with the 1st gen to 3rd gen swap.I dont know if that nmakes a difference.Dawg, I didnt see the pic of the steering box.
Stan