Ricks67
Aug 23rd, 04, 11:10 AM
Here is an update on the installation of the AFCO Solid upper and Light Weight Lower A-Arm Bushings:
Mind you, I only have ~30 miles and one autocross event on them so far, but they seem fine. No noticeable increase in noise or vibration. These steel bushing are installed in stock A-Arms, as compared to the FatMan A-Arms (narrowed) with Poly bushings that were on the car before.
Other changes done at the same time that may or may not have influenced my noise/vibration perception:
Spring weight went from 500 to 750.
2" Lowered Spindles back to Stock Spindles.
Added Hotchkis 1-1/8 sway bar.
Mind you, I only have ~30 miles and one autocross event on them so far, but they seem fine. No noticeable increase in noise or vibration. These steel bushing are installed in stock A-Arms, as compared to the FatMan A-Arms (narrowed) with Poly bushings that were on the car before.
Other changes done at the same time that may or may not have influenced my noise/vibration perception:
Spring weight went from 500 to 750.
2" Lowered Spindles back to Stock Spindles.
Added Hotchkis 1-1/8 sway bar.