I know this should be a no-brainer but...

Is there a special socket I need to get my Hooker Header Bolts out??? I don't have the world's best collection of tools but I do own "a few" sockets! ;) I just don't own one that fits those bolt heads! :-(

Thanks!

I believe they are the TorX bits. they look sort of like a star , you can get a complete set almost anywhere for around 40 bux.

------------------
http://www.67rs.com/macphreak4evr/chrissig.gif
Chris's 67 RS 327, Comp280,Flowmasters,shoddy interior, pepboys carpet and rusty floors and trunk can be seen at http://www.67rs.com
JOIN THE CAMARO NET WEBRING!
http://nav.webring.yahoo.com/hub?ring=camaronet&list

Unless you want to hear header leaks and enjoy changing header gaskets forever, get a set of Stage 8 locking bolts or ARP pre-drilled NASCAR header bolts (small 3/8" hex) and safety-wire them after a couple of heat cycles, and you'll never have to touch them again. Been there, done that, for many, many years (safety-wired ARP bolts), never had a leak or blown gasket yet.

------------------
JohnZ
'69 Z28 Fathom Green

Rob, If you don't have one that fits, Bob (Mobile Tools) has one or can get you one probably overnite (very cheap too!).....Scott
http://www.mobiletools1.com/



------------------
69 RS/SS 427 4.11's
2000 Z28 Navy Metallic LS1 6 Spd T-Tops