I tracked down the guy who put together the small block in my 68 (two owners ago). He built the engine/trans in 1989, raced it a couple times and ran out of $$. graemlins/sad.gif He sold it to a guy in 1991 who then stored it until I bought it last fall.... Anyway, he says that he bored it .006 over, installed a 3/4 Crane cam, left the steel crank and installed hi perf pistons to make 11:1 compression. He said he made it a 364cid. Can that be right? He told me it ran a 12.60 quarter graemlins/thumbsup.gif

WHEN WILL THIS SNOW GO AWAY AND LET ME GO OUT AND PLAY!!!

It might be a 3.625" stroked crank engine that the Roundy-Round guy's run b/c I haven't run the numbers to figure it out size wise... pdq67

If he bored it .060 (60 over) then the displacement comes out at 360.4 cubic inches.