I have a 350 .060 over with camel-hump heads 64cc 2.02 valves about 10 to 1 compression.
I have a summit 488/510 lift cam
RPM Air gap intake
750 double pumper
Headman headers, 2 chamber flows

(3.73's with a 3000 stall converter and t-400 tranny)
The reason that I am asking is that I raced a Mitsubishi Evo today and killed it, I don't if the guy could not drive, but that is 13 sec car. He beat me off the line but onnce I hooked up it was over. Then we did it again rolling and he never got closer than a car lenght. What is the deal!

Say roughly 440hp, 420 tqu

Imho, you have just enough compression for the Summit version of E-brock's RPM cam to work!!

11 to 1 CR. would do better but then you couldn't feed her..

pdq67

Has any work been done to the camel humps? I'm not familiar with the cam, but if I had to... I'd guess that the combo is good for around 350-375 horses.