Guys, tried a search on this subject and came up empty. Does anyone know if spade terminal for ignition in the fuse panel is fuse protected? How about the battery & accessory terminals? I was looking at my electrical diagrams yesterday and couldn't find this information. All the bulb wattages are listed, the fuse ratings, the fusible links are covered, the in-line fuses, even the spotlight but nothing on the terminals in the fuse panel.
I put a QJet from a 79' Corvette on my Camaro and converted the stove pipe choke to electric so I wanted to wire it from here.
Thanks !

------------------
Drew

69' X-11 350, Turbo 350, Factory Air, PS, PB, 12 Bolt (410 gear) & NOT AN SS

I can't remember for sure. It's been a while since I had a fuseblock off to see the back. Look at the fuse directly to the left or right of the terminal in question and see if it corresponds with the terminal. Ex. IGN terminal next to a fuse that only has power when the key is in the run position. Take that fuse out and see if the terminal goes dead. Worth a shot.

------------------
'69 RS Camaro
355 5-speed 4.11

1 2Run, Thanks that is worth a shot. If that doesn't work I'll add an in line fuse for the circuit.
Drew

Drew, all of the center blades are fused. The outside fuse holders are the 'feeds in', and the center fuses, and blades are all fused 'feeds out'. Hope this helps.
Skip
tech@factoryfit.com

[This message has been edited by Camarocopo (edited 07-24-2002).]

Thanks Skip, I knew somebody out here had the answer. http://www.camaros.net/forum/smile.gif