I took the gas tank out of my Z about a mouth ago put in a new tank now the gage goes all the way to Full. I have made sure that I did not pinch the wire (Brown)that gose to the Sending unit and made sure that the ground was on good. I am going to take the tank back off to night. How should I go about checking it. If I unplug it it should go to "E" wright or not.

TIM

It's the other way around:

Past full = open circuit

Empty = grounded

Either a bad sending unit or a bad ground.

------------------
Don~ ZZ430DropTop (http://hometown.aol.com/zz430droptop67rs)
~~~~and~~~~
70 RS/Z28 (http://hometown.aol.com/performancespecs)
67 RS/SS Convertible, 70 RS/Z28

[This message has been edited by ZZ430DropTop67RS (edited 07-24-2002).]

Thanks a lot. Well see what it dose to night I will clean the ground up some and see if that helps.

TIM

Thanks for the help. Had to take it apart fixed it put it back in and it is working now.

THANKS TIM