Has anyone used the Autometer fuel gauge to install in the AutoMeter Camaro console pod?
Do the ohms match close enough to the stock sender unit to be a direct swap?

Just ordered the pod and gauges. Probably should have asked this question first!

Thanks

joe

------------------
69 Rat-Infested Resti-Clone
WCA Member
Badboatdude@CS.com
69 Pics http://hobbystage.net/camaro/joeg/index.html

Close enough?...The stock GM sending unit is 0-90 ohms....You have to match the fuel guage to that resistance range...
0 ohms=Empty 90 ohms=Full

Thanks. It sounds like it's close enough to work. I guess I'll find out soon.

joe



------------------
69 Rat-Infested Resti-Clone
WCA Member
Badboatdude@CS.com
69 Pics http://hobbystage.net/camaro/joeg/index.html

Joe, it should work perfectly, I have a 2-5/8" Autometer gauge installed appart in the dash (my car doesn' have dash gauges) and it works right. Just swivels a little bit as the fuel moves inside the taks. Now this one is going to be replaced by 2-1/16" gauge on the console pod.

------------------
Our affair with Camaros is a live sentence without the possibility of parole. www.geocities.com/c68ss (http://www.geocities.com/c68ss) http://home.coqui.net/borench

Joe, I have the Autometer pod in the '68 & I hooked it up from the original (M&H) fuel tank sending unit. Works just fine.
Dan

------------------
http://hobbystage.net/camaro/dsmart

Cool!
That's what I was hoping for.

Thanks a lot, guys. http://www.camaros.net/forum/biggrin.gif

joe

------------------
69 Rat-Infested Resti-Clone
WCA Member
Badboatdude@CS.com
69 Pics http://hobbystage.net/camaro/joeg/index.html