this should probably be in the wiring section but i'd like to get a response tonight and it's also an update.

ok... so far i've got new headers and new spark plug wires on the thing. i've installed the painless fuse block (after installing that thing i realized how painful things were gonna be) and i've run all the wires to see how it'll all work but a few loose ends (figuratively and literally) are holding me back and i would like to burn the midnight oil and just finish the thing tonight.

to start, does anyone have a good link to a wiring schematic for the 67? the only problems i'm running into are the ones pertaining to stuff i don't have in my car. namely, i don't know what to do with the neutral safety switch wires, the reverse light switch (does my m-20 even have one?) and the heater wires. i took out the heater controls because i want to put my guages in their place and clean everything up a little, and the fan was isolated to a switch before anyway, but now i've forgotten how to wire it in. other than this stuff i should be able to figure everything else out.

thanks for your time, you guys are awesome.

Neutral safety switch, 67's didnt have them. They used the backup switch. Should be located on the linkage to the tranny reverse arm. As for the heater controls.. tape em off and wrap them up and tuck em away. You may eventually reistall the heater. If the heater is gone with the housing, then no use for the fan switch or fan.