How do you remove the Camaro emblem from the glove box door on a 68? Preferably without damaging it. I want to repaint the door.

Reply only if you have successfully done this before.

Originally posted by Tork:
Reply only if you have successfully done this before. Just some friendly advice. Try just asking for help and when you get a reply acknowkedge it. Even if someone hasn't done the deed they may be sitting in the passanger seat thinking about the exact same thing. 2 heads are better than one and others input may be all the catalist you need to figure it out.

Have you gone through the '68 AIM (Assembly Instruction Manual) to see how it goes together?

Please post how you end up removing it so others will know.

Just get a small pocket scewdriver and gently pry it up. There are no retaining nuts or screws, there's only very small push-in retainers so be careful not to lose any of them or worse let them fall INSIDE the glove box door!

Thank you 1967 Panther. Previously, I could see the top of the retainers and I tried prying. Obviously, I didn't pry hard enough.

I took a look at the photos. Nice car!

Thanks..I really don't want to keep showing th links to my car pics, but it automatically adds them even when I uncheck the box...

I just took mine off the glove box of my 67 and there are no retainers. The previous owners had just wrapped some black electrical tape around the prongs until he had a tight fit. It actually works fine so that is how I re installed it. Not sure if is the same on a 68.
Scott

Sudo, 67's don't even HAVE an emblem..you must have a 68 door..