Help me out guys. Does the upper clutch rod rubber boot install on the engine side or install from the passanger side with the boot sticking through the hole?

It installs on the engine side with two sheet metal screws.

Thank you.
Chris

I also used a dremel to slightly enlarge the boot hole so the rod would easily slide. Else, it was contributing alot of stiction to the clutch action. This was a repro boot and would have torn otherwise after not too long.

You could rub a little silicone lube on the clutch shaft so you don't have to enlarge the hole. The boot is actually supposed to remain in one location on the shaft and expand and collapse when the clutch is used.

This boot is still available from GM #3909071 and is much better than the repop. No trimming or silicone required.
Jim graemlins/waving.gif