Checked power to motor, was ok. Attached direct power to motor without any results. Would like to remove and replace motor without removing fender. Is this possible? Any advise would be apprciated.

I have a 69 Camaro. I think the 67 is the same. You will have to remove the fender to get the blower motor out. Only one possibility is to remove the inner wheel well, but I think this is just as difficult as removing the fender. You may be able to move the fender enough to get to the last blower motor bolt if you are lucky. Anyone with other ideas?

The GM method is to cut an access opening in the wheel well. Cut three sides about 3x3" (sides and bottom) fold flap up, R&R fan, fold flap down and caulk.

Bob.

ive changed heater motors before and you remove the bolts at the bottom of the aft fender and and the wheel well and pull the fender out at the bottom and put a two by four to heep it out and you can get the motor out