what is the trick to get the window back in the rubber strip in window track?? :confused:thanks

Remove the interior panel from the door, roll down the window to view the two studs bolting the window bottom clamp to the regulator. Unbolt the frame from the regulator and pull/push window into rubber track. Rebolt everything back together.

Or, remove interior panel, roll window down, unbolt the bottom of the rubber track from the door, pry track about window edge, bolt track back to door. Make sure bolt goes back to the same spot as shown by the paint/dirt marks.

Oh, get the handle removal tool from your local parts store to remove the widow & door crank handles, note positon of both before removal.

This tool is flat with a 1/2"(?) wide section cut out to remove the clip holding the crank handle in place. The tool slides between the handle and the plastic panel protection washer, the grab portion of either handle goes over the tool, and push out the clip, pull the handle off. Once the handle is off, replace the clip back onto the handle, open end to the grab portion of the handle. This will prevent from losing the clip later. Use a #3 Phillips screwdriver to remove the armrest.