I just want to make sure about the hole size I should be using for the subframe mounts. Mine are totally shot. I've seen a mention of 1.5" but wasn't sure it was right. can anyone confirm if that is corect? If anyone has templates for the repair I would love it if you would email them to me. thanks

1.5 is correct. A holesaw will do the job nicely. I have templates. I will need to scan them.I'm not sure if scanning will retain the right size of the template.

You have mail.

Shoddy,
Got it. Thanks a lot.

buy the kit with the correct sized metal at any of the camaro resto places.

only 25 bucks and your sure to get it right the first time

The 'kit' is just some washers with a 1.5" center.It doesnt guarantee proper placement of the 'hole'. I did three different subframes with a slab of steel that i got out of a scrap pile for free. Buttwelded it in ground it flush, drilled the hole. Less than a half hour on each mount,undetectable and it was free. I could use that $25 on something i really need.