The good and the bad,,,

Good- Found an original drivers fender at a local swapmeet-Perfect condition..150.00 :D

The Bad- Broke off lower fender mounting bolt by drivers door ,drilled out and then broke off easy out in the hole!!!! :angry: :angry:

Any ideas how to get this sucker out????Someone said to just drill another hole alongside and tap that and use it instead... :clonk:

Thoughts?????

That was me, I think. Did that to the hood stop adjusment boltholes on the rad support.

I also have a broken bolt, drivers side fender near door, no easy out tho. I will run a drill and a tap thru that sucker, and hope it's rusted hard enuf to keep it there.

I broke my tap in that same hole. Then killed 2 drill bits trying to get it out. I ended up getting a threaded rod, putting it in the hole with shims to space the fender then a large washer and nut on the bottom. It's pretty half a$$ed but the only thing that worked.

If there is enough of the bolt shank exposed you can weld a nut to the shank. The heat from welding will also help to free a rusted bolt.