Hey all, there's light at the end of the tunnel for me and my Ragtop Resto... 6 long years... and counting...
The car is now back together, running and driving, and am now working on the "small" details.
I'm having a few problems though,
The top wiring and the harness for the rear wiring (power convertible top, 1968 car) However I lay rout these it seems they will eventually fail due to the top frame pinching them. Does anyone have a picture of the proper wiring routing in this area, also helpful would be the routing of the top hoses.

Thanks
I have the assem. manual but it seems real vague..
Thanks

As best my memory serves me (!) when I removed the wiring from a parts car, they ran through the driver's side wiring channel front to back, then went around the seat back side to come out in the middle where the pump is. I don't remember any particular clips or special routing.

Line routing-
http://pg.photos.yahoo.com/ph/ochrisl/detail?.dir=634c&.dnm=62b2.jpg&.src=ph

Wire routing-
http://pg.photos.yahoo.com/ph/ochrisl/detail?.dir=634c&.dnm=28b8.jpg&.src=ph

Shoddy, Awesome pics, just what I was looking for...
The wiring for the entire rear clip runs this way, or just the pump wires?? (looks like it all does from the pics you posted, but I just want to make sure)
I'm away from the car right now, and am having trouble envisioning where the rear harness pops into the area behind the seat.
Thanks again!!

Can someone post new pictues. The links above are not working. I need to route the rear harness and I don't remember which way it goes.

http://i12.photobucket.com/albums/a214/shoddy_f-body/other%20stuff/DSCF0097.jpg?t=1200110913

http://i12.photobucket.com/albums/a214/shoddy_f-body/other%20stuff/DSCF0098.jpg?t=1200110950

http://i12.photobucket.com/albums/a214/shoddy_f-body/other%20stuff/DSCF0099.jpg?t=1200110980

Thanks! I needed those too!