I am in the process of replacing the old rubber bushings with new poly bushings. After I got the old bushing out today, I am not sure what I reuse with the new bushings. I have the bushing that goes underneath the support with the steel insert...and the part that goes on top...but they don't appear to be made like the originals. The hole through the center is quite a bit bigger than the original bushings also. Does the steel washer with the part that goes up through the bushing get reused? Thanks for all the help, and I am not sure if I put this in the right forum...but I figured some of the originality guys might now the answer.

Gambitt

Has no one replaced these bushings with poly bushings before?