http://www.kodakgallery.com/Slideshow.jsp?&conn_speed=1&collid=79041156608.30320460708.1137309187515&mode=fromsite

Thanks

1967 RS/SS Camaro A/c, Ps, Power Disc Brakes, Fold down rear seat, 12 bolt .........

Maybe this will work

http://www.kodakgallery.com/Slideshow.jsp?Uc=10b72ark.dxg0p7o&Uy=-63wr62&Upost_signin=Slideshow.jsp%3Fmode%3Dfromshare&Ux=0&mode=fromshare&conn_speed=1

Not clear enough picture.

No expert, but looks good to me.

That tag is good.

Thanks for the replies.

tag looks good, does it match body vin?

how does it match the vin #?

Vin# is 124377N171491

The vin lines up just fine with the build date listed on the tag. I'd say it is original to the car.

Bobrancharo have you (or can you) post any other numbers from this car for the folks at CRG? Trans, motor & rear end stampings?

I have the original 12 bolt with the traction bar bracket welded to it and the plate in the right rear floor, If I keep it I am going to aquire a traction bar and bracket to install back to original.
Rear end #'s are QK0104G E

3:31 eaton posi
NO motor or trans and needs all new sheet metal in the rear and rear floors.
I'll post pics later, going to eat.

Does it still have it's bench seat?

Yep, I have the bench seat and I think I like it better than the buckets.
I'm missing the rear seat(bottom), The A/C box with the fan on firewall ect...

I'm still trying to decide if I should keep it and spend the 15-20K on it or sell it,
What would you do???????

Here are some pics of the car

http://www.kodakgallery.com/Slideshow.jsp?Uc=10b72ark.smt8l2s&Uy=-y2ol1a&Upost_signin=Slideshow.jsp%3Fmode%3Dfromshare&Ux=0&mode=fromshare&conn_speed=1

Heres what i get when trying to look at your picture.

The page you're looking for is not available.

But don't let that stop you. You can use your browser's back button to return to the page you were on. If you are having problems using our site, please browse through our help section.







©Copyright 1999-2005 Kodak Imaging Network, Inc. All Rights Reserved.

It should work now.
I'm new to this and I will check out all the ins and outs for posting.
Thanks

http://www.kodakgallery.com/Slideshow.jsp?Uc=10b72ark.smt8l2s&Uy=-y2ol1a&Upost_signin=Slideshow.jsp%3Fmode%3Dfromshare&Ux=0&mode=fromshare&conn_speed=1

With that date, there's the chance that the brackets were installed, but no radius rod was installed.