Can anyone tell me the exact location of the lower windshield support clips on my 67 coupe. I did a search and found the trim clip location but not the support location. Thanks....

Are you wanting the location of the windshield setting blocks?

------------------
Jim
67 Camaro SS Conv.
70 Challenger R/T Conv.

There are two windshield support clips that are screwed on the upper cowell that support the windshield. They may be called setting blocks. They are L shaped brackets.They are listed in the parts catalog as "Windshield Support Brackets"
Thanks.....

sschuell,
It sounds like the upper dash panel has been replaced. If so, you will probably have to use the windshield itself to get the proper location. It will take 3 people to do. The top of the windshield should have about 1/4" - 3/8" clearance from the front roof area at the lip where the windshield sets in the cavity. Having one person on either side of the car, holding the windshield in the proper position, you can then mark the location. They were installed at the factory to keep the windshield from sagging after it was first installed (the seal would sag allowing the windshield to drop)

Thanks for the reply.The dash has been replaced. Do the setting blocks go against the support clips?