Mike68RS
Feb 3rd, 06, 12:33 PM
Does anyone know what is the bracket for that is welded above the clutch fork opening on a Lakewood 15000 bellhousing? I want to remove it as it gets in the way of one bolt and adjusting the offset dowel.
Mike
Mike
|
View Full Version : Lakewood Bellhousing question Mike68RS Feb 3rd, 06, 12:33 PM Does anyone know what is the bracket for that is welded above the clutch fork opening on a Lakewood 15000 bellhousing? I want to remove it as it gets in the way of one bolt and adjusting the offset dowel. Mike 12run Feb 3rd, 06, 02:54 PM I'm not positive, but I believe it's for mounting a slave cylinder if you're using a hydraulic clutch setup. GMJim Feb 3rd, 06, 04:43 PM Mike68RS It's for a slave cylinder like 12run said but also for a pivot ball. If you don't require it you can cut it off. Mike68RS Feb 3rd, 06, 04:55 PM Thanks guys, Off it goes! Mike |