emdoller
Mar 20th, 06, 08:10 PM
While I'm waiting for my M20 to arrive (comes with shifter and linkage), I'm wondering if I have forgot any of the other parts I need to complete the PG to M20 conversion. Here's what I ordered:
Summit Racing
Flywheel and bolt kit
Clutch, pressure plate and bolt kit
throwout bearing
pilot bearing
Ground up
11" bellhousing and bolts
manual trans conversion kit
clutch pad
shifter boot
shift boot retainer
clutch fork
bellhousing fork boot
bellhousing inspection cover
clutch fork ball
reverse lamp kit
Am I missing anything?
Thanks!!
Ed
BNZFixr
Mar 20th, 06, 08:15 PM
Sounds like you have it all covered:thumbsup: . What is included in the conversion kit?
emdoller
Mar 20th, 06, 08:45 PM
Sounds like you have it all covered:thumbsup: . What is included in the conversion kit?
The conversion kit includes:
Pedal Assembly
clutch firewall rod
attaching clips
firewall rod boot
clutch return spring
clutch z bar
clutch adjusting rod
spring
clutch cross shaft kit
clutch fram bracket
I think that's it...
JimM
Mar 20th, 06, 08:52 PM
only thing I don't see is a brake pedal pad.
Is your muncie a driver side or pass side speedo?
if it's pass side, you'll need the longer speedo cable.
emdoller
Mar 20th, 06, 09:26 PM
only thing I don't see is a brake pedal pad.
Is your muncie a driver side or pass side speedo?
if it's pass side, you'll need the longer speedo cable.
Your right about the brake pad!! I need to get one.
Not sure about the speedo cable... the M20 is out of a 69... the tranny will include the speedo cable so I'll wait and see.
emdoller
May 16th, 06, 04:27 PM
My conversion is done!! I needed a new starter because i went with a 11" clutch but other then that the list below was complete.
I can't tell you how happy I am that i did this. What a difference... it's actually fun to drive and has 2X the power.
If your thinking about doing this, run and do it.
Ed
blainedoe
May 16th, 06, 04:55 PM
emdoller does your holes line up for your bracket on the frame???
Straight-line-69
May 20th, 06, 09:50 PM
There are two Z-bar ball studs,..engine side and frame side.
Ball-stud for the fork?
Pressure plate bolts?
Tranny-to-bellhousing bolts?
New tranny mount (might as well)
Firewall boots?
Neutral safety switch (or you'll need to hard wire/bypass it)
Shifter?
Shifter rod kit?
Speedo gear (might come with the tranny)