Hello everyone,. Im looking for vertical dimensions for rear rails 69 camaro. I have the frame chart, I think I have seen it on this site before. The chart appears that 2 of the dimensions are reversed or incorrect. If I was computer savy enough I would upload the chart I have. On my chart the distance is greater at the shackel mounting hole than at the center bottom of the side rail which is impossible. Any help is greatly appreciated.

is this what you saw? its out of the chassis manual directly. where is there an error?

http://www.brainerd.net/~knudsen/69RS/FrontEndProject/69FrameFisherMeasurements.jpg

Jim, I need the verticle measurements. E,F,G the bottom diagram. On the sheet I have, the dimension for "g" is greater than letter f. So I suspect the #'s on my sheet, could be completely off? or maybe just be reversed? Do you have the comparetive dimensions for vertical - E.F,G?? Both rails are pushed up so I cant just compare the differances between efg, on one side and use it on the other. I need to do a pull on both side rails. Thanks for getting back to me so quickly, any more help would be much appreciated!!

The chart I have isnt of the same orgin as the one you posted.

I have to find my chassis book and will post what I find, probably on Thur.

E is 6 15/16 to the master gauge hole in the side of the rail, F is 18 7/16 to the bottom of the rail at kickup on either side of rear axle, and G is 15 11/16 to the bottom of the rail at the centerline of rear axle shackle bolt hole.

thanks Mark I will modify that chart now. :)

I added the other dimensions to that chart above now. :)

Thanks guys. You saved my butt.