It's been a long winter. I finally got most of the rusted metal out of the drivers side floor and am planning on putting the drivers side rocker in along with the floor.

I've become fairly familiar with all the connections from the floor and rocker. However, I have been unable to find a lot of information on the image below. The picture is of the rear of the drivers side where the rear-subframe and springs connect up. This piece looks like it needs to go but I want to make sure I can get a replacement first.

Any thoughts ???

http://static.flickr.com/46/129597292_eb21230971.jpg?v=0

I'm not sure they sell that piece.....

The piece is a Torque Box. As far as I know no one makes a repop. Usually the Full floor pan comes with them already, not sure about half floors though

They aren't repro'd. You either have to get them with the full floor, or cut your old ones off, or get some off a donor, or fabricate some. No other repro'd floors come with them attached besides the full floor.

Thanks. Sounds like I might do well to get the full floor and eat the cost. Looks like there might be a couple of other benefits as well.

Thanks again,
Thomas