Finished the installation of my CE subframe connectors and everything went fairly smooth. Didn't get to try it out tonight since I was filthy dirty but will give it try tomorrow. One thing I noticed it that it is hard to get both bolts on each side with the bushing and large bolt installed. I kept working at it and finally got it though. This is not a daily driver but only on weekends, etc... I ahve a mildly modified 454 and know I should have had teh subframe connectors but didn't. No twisted paint damage yet. Can't wait until tomorrow to try it out. I did replace the bushings with poly bushings also. Will I need to weld the subframe connectors in as well as bolting them, I have read some do and some don't. Suggestions welcome!!!!

Wow! The poly's were a great choice. I have Poly's on mine and boy did that tighten things up a bit. I am doing subframes also, although I have no where near the torque you are running. At any rate you will notice the snap big time, and it was a great investment.. I know your camaro will like it.