Hello!

Could anybody send me this instruction?

Thanks for any help!

Perhaps some pictures from the bar already installed => This would be fine!

Hi Markus
I think this might help
For Dealer and Sales Information,
call 1-800-367-5480
or e-mail at customerservice@hellwigproducts.com

Thay might be able to help
Larry

I don't know about a Hellwig rear sway-bar, but my 3/4" ADDCO S/B mount's under the rear with a pair of clamps and points forward!

I had to drill a couple of holes in both Uni-body S/F's in the slant and then thread a square "U"-bolt through the two holes and then bolt on a fishplate and the rest of the link attachment mounting hardware.

Real easy job to me!!

I do recommend using poly instead of the rubber stuff if yours comes with rubber like mine did.

One thing I have later done is to use better hardware, like longer re-threaded Grade-8 bolts and such here.... And you really need to set the link spacing up on the ground as usual for all suspension work!!!!!!!!!!

I will say that I like a rear s/b, but be prepared for a bit of pushing which I compensate for by throttle!!

I have ALWAYS powered my car into sharp turns is all here.......... But, then again, my car was always set up so stiff that it almost skipped sideways at speed turning a FAST 90 degree street corner!!

pdq67