Im doing a Baer brake set up with hydroboost and looking to purchase a simple Tee for the master to front caliper line distribution. I dont want the one with the switch in it for front and rear lines. Just a simple one in and two out. Anyone done this, that can give me a source to purchase.

Also is 3/16 line the correct size to come out of the master to the inlet of the Tee?

Thanks Rich

Most good parts stores that carry Eastman or Weatherhead fittings, have those special inverted flare tees. sounds like you want to come straight down with one big line from the M/C the tee off with two smaller lines?

yes 3/16 was the factory size and works fine for me, and i have a 't' setup like you describe

400,

If possible can you shoot me a pic of your configuration, and where did you get the TEE?

Thanks Rich

sorry, no pictures of the car together right now, its all apart. I just finished painting the inner fenders, sub, firewall...
i could get you a pic of the part itself with 2 brake lines going to it but no master cylinder, i will try and get that picture for you in the morning

i bought the tee from a local chain, monument car parts
but i know napa carries inverted flair fittings
what you need is a 3/16" inverted flair tee

if you cant find a tee locally summit carries one part # GAR-J9035
good luck