i have a 67 with a non posi 10 bolt (will change that later! huh....) anyways i just got my disk brake conversion kit and in order to do what i need to do i have to pull the axles. i took the diff cover off now what?? thanx for any help i have to learn alot of this stuff on my own so sometimes it's a little slow. Rich

You will see a 3/4 inch shaft (might be 5/8 on this rear end) running through the center of the differential with 2 gears on it. There is a bolt that goes in from the side with a 1/2 inch head on it. Remove that bolt and the shaft will come out. Push the axle in and remove the c clip that is on the end of it. Then you can pull the axle out. Be carefull not to turn the gears inside the differential (there are 4 of them) because you will get them out of alignment. If you do then you might have a hard time getting them back in place with the thrust washers behind them. I recommend putting the shaft back in place until you are ready to install the axles again.

thanx a million i appreciate it.. :)

well i got the new rear discs on wow theyre shnazzy. thanks again for the help it was actually really easy. thanx again, Rich

Glad to help.

BGH,

Please answer this guy for me b/c i flat forgot the link to the thread on this that we posted on recently.

http://www.camaros.net/forums/showthread.php?t=87595

Thanks,

pdq67