does anybody have a full parts list or IPc of a chevy 12 bolt posi?

i wanna get this one from a person and i just wanna make sure its all there see pics...

so far im thinking...

spider gears and pin with pin bolt

C clips

disc brake pads

pins to hold the pads

brake fluid(kidding)

ring and pinion gears

shims many shims

bolts to fasten the ring gear to the carrier(12 bolts look at the carier see the holes?)

crush sleeve

spider gears.

auburn posi unit

all bearings ie: axle bearings. carier bearings..

correct bolts to bolt the brake assemblies to the end of the axle tube.(4 bolts each end)
http://i25.photobucket.com/albums/c74/1963wagonman/ShowLetter.jpg
http://i25.photobucket.com/albums/c74/1963wagonman/ShowLetter5.jpg
http://i25.photobucket.com/albums/c74/1963wagonman/ShowLetter4.jpg
http://i25.photobucket.com/albums/c74/1963wagonman/ShowLetter3.jpg
http://i25.photobucket.com/albums/c74/1963wagonman/ShowLetter2.jpg
http://i25.photobucket.com/albums/c74/1963wagonman/ShowLetter1.jpg

That is a 4 series Eaton posi case. Don't mess with an Auburn posi. They are junk. I have new gears, clutches, shims, cross shaft, retining bolt and all of the other parts that you need to put that Eaton together. You will be limited to a 3.73 to 6.xx gear set with the 4 series. The installation kit has all of the other parts that you need, shims, bolts, spacer... Those are Moser axles in that box, but I don't see any axle bearings.