Purchased the Classic Template 68 SS kit, followed the instructions and now my camaro's fender emblems look higher than other cars, about 3/8" of an inch higher. So has anyone had any problems with this kit?, I just painted and now I get to fill holes and START OVER!, If someone can post a good picture of their Camaro SS with the correct fender holes, would be very helpful, thanks.

My template was purchased at NPD and it is for an SS 396, don't know yours. It worked fine, just needed some little hole marks relocations prior to drilling to make sure the emblems stems fit right. I compared the results with a photo of a restored car on the Year One catalog and I'm satisfied. Sorry, no photo to help you but took dimensions on my cars emblem locations. From fender horizontal bodyline up to the vertical center of the Camaro emblem (not the C letter of it)=1-5/16". From that same bodyline down to the vertical center of the SS emblem=1-3/16". From fender edge (door gap) to horizontal center of Camaro emblem=8-11/16". From same edge to horizontal center of SS emblem=8-9/16". Hope you can understand this and that it help you...