I am needing to adapt a 1/4" inverted flare to a 3/16" flare port on a proportioning valve. So the 3/16" will be the male going into the valve, with a 1/4" brake line and fitting going into the female 1/4" adapter.

Does anyone make anything like this? With the correct inverted flare surface on the male 3/16" end? I found 1/4" to 3/16 NPT but not the inverted flare that matches up with brake valves and master cylinders.

Thanks

Hello,

Good luck on finding that fitting. I needed one to install the new SSBC Adjustable Proportioning Valve and Distribution for the rear line. Anyway I looked high and low then I found them at Pep Boys on the shelf. They are made by Motormite PN 43303. It looks like partsamerica.com sells them as well...
http://www.partsamerica.com/ProductDetail.aspx?mfrcode=RNB&mfrpartnumber=43303

Jeff

My local NAPA has an impressive "Weatherhead" fitting inventory in pull-drawers behind the parts counter - they haven't failed me yet ...

I have 2 of them in a drawer. NAPA Weatherhead.

Thanks guys. I will have to go to Austin for a Pep Boys, so I will search out a Napa.

Found them in Austin at a Pep Boys, bought extra....