I have a replacement trunk floor pan installed and have no idea on the location of the Spare Tire Clamp Anchor Plate. Can anyone help me by locating the two holes I need to attach the plate to the floor pan? The factory assembly manual UPC 10 A2 helps but does not give dimensions. http://www.camaros.net/forums/images/smilies/confused.gif
:confused:

http://www.camaros.net/forums/showthread.php?t=54741&highlight=spare+tire

Thanks for the input BUT it does not help me since the floor mat is already installed and have no idea where the new floor pan is in relation to the old pan. How about inches from right rear quarter panel and inside rear panel.

When I get home from work tonight I'll dig out the photos I took of my original with measurements and send them to you if you have a email addess.

here are some pics hope they help used 1 inch wide tape measure.

Thanks for the quick reply, the pics are really great! Do you have any idea how far from the right side to the right side of the anchor plate?

Thanks for the quick reply, the pics are really great! Do you have any idea how far from the right side to the right side of the anchor plate?

Just straddle that molded rib in the floor pan and you can't go wrong...

My replacement does not have a rib. Need inches from right dip.

The right side of my "loop" for the bar/bolt is 5" from the right side of the pan.

Hope that makes sense.

Thank you, Thank you this should take care of my needs!