I'm looking for a cpl of pictures. Prefferably old ones you have already taken so as not to cause any extra work.

The first is pretty simple. It's just a good picture of the windshield wiper motor as attached to the firewall. I'm relocating my wiper motor and want to make sure it's mounted at the right angle.

The second may not be as easy for most. I'm replacing the upper dash and doing some rust repair. What I need are some pics of the front part of the dash where it meets the windshiled. What I'm looking for are pics to help relocate the two windshield supports and the lower windshield chrome trim. My car is a convert so it may be a little different that a coupe. So for the second pic I'd prefer them to be from a convert.

So if you currently have the cowl off and can get some good clear shots of the area of the dash/windshield I'l looking for I'd appreciate it.

I'm at work and don't have time to go through my pics, but you're welcome to go through them and see if there are any of what you need. I think there might be.
http://www.67rs-ss.net/my67/gallery.asp

Do a search in the body shop section for Windsheild molding holes and you should find a few posts with the measurements. Convert and coupe lower moldings mount the same, except convert does not use the end clips on the A pillar

Did you find the pics that you were looking for? If not, I may have them.

I've got some pretty good ones of the wiper motor. Still looking for the lower windshield stuff. Have some ok ones but someone might have better.

Does this help? It's one I took a few years ago when the windshield was out...on a '69.

http://img.photobucket.com/albums/v61/gort69/DCP03920.jpg

check in my photobucket album below. I have a pic of the dash I replaced. Hope it helps.....

Sorry....just realized you need pics of vert..

good luck

Try this or look at the other picks in my link to photobucket I can get more if you need them just pm me.
Bob


http://s68.photobucket.com/albums/i37/Mud_Rat/?action=view&current=PIC00027.jpg

Thanks Mud Rat. That worked for the wiper motor. Now if I can just find a pic wthe the cowl off and the windshield and trim still in place.

Like I said, have you found what your looking for? I more than likely have what you need. Just trying to help.

Bird -

The thread below contains a picture of my original dashtop with the molding holes and windshield supports marked, so you can get a visual. There is also a link to the dimensions I had. The molding clips slide, and the windshield supports move up and down, so it's not critical to locate them to the nearest nanometer :) .

http://www.camaros.net/forums/showthread.php?t=85374&highlight=windshield+molding+holes

Bird -

The thread below contains a picture of my original dashtop with the molding holes and windshield supports marked, so you can get a visual. There is also a link to the dimensions I had. The molding clips slide, and the windshield supports move up and down, so it's not critical to locate them to the nearest nanometer :) .

http://www.camaros.net/forums/showthread.php?t=85374&highlight=windshield+molding+holes

Thanks Eric. I think between the picture you posted, the other pictures folks posted, and the other post with the measurements I now have what I need. I appreiate all the help I received from you folks. Once my dash and windshield are inslalled I'll take pics like I was lookign for so it may help someone else in the future.