To those of you that have installed Globalwest alum. bodymounts, I was needing to know if they are suppose to fit snug in
the fram mount holes or just a little loose?
I started on the pass. side since I had just replaced the floorpan but had to wait on
the mounts before final welding of the seat mount (wanted to make sure everything was going to line up) the holes in the fram are not rusted out and are perfectly round.When I installed top bushing (one that slides down into fram rail) I noticed it fit a little loose I can move it around about 1/8th
inch of play is this normal to allow for slight fram hole dia. differences. I'm doing one at a time just somthing I happen to notice. sorry so long
Jeff

There is a little play. I've had mine in about a year with no problems. Once you tighten everything down, it stays.

Thanks for the quick reply Rick, Sometimes
those little things bother me.LOL
back to work.
Jeff