When I got my car the front subframe was hacked off about 5inches and had some bars welded on for a tilt front end.. which I got rid of, and due to there crappy job of welding the bars on I cut on the sides and bottom of the front subframe about 9inches on the bottom 9inches on the outerside and to the big 3inch hole on the inner side. I then added 1/8 plates and had a friend mig them in and just boxed it in with a bottom pc.

so since the bottom pc blocks you from getting a tool up inside for the bolt or hardware to mount a core support which hole does it mount to? Front middle or back, I just plan on using a hole saw and cutting a slighty bigger hole in the bottom.

Ill throw a pic up later today of what I did to it as well a before and after aswell.

Front :thumbsup:

ok thx, btw what are the other holes for?

Im not 100% sure but I think theyre for other models, such as Novas, etc :confused:

didnt even think about that but possibly = )