Does anybody make a rubber gasket for the back up lights. going between the light and rear body panel.I know GM never did but I was hoping somebody got smart and made something up.

Mark I would try buying some of the clear decal chip gaurds used on late model cars and cut your own. I assume your doing this to keep lite from digging into paint. Look around on internet, i've seen some companies sell sheets ED

I cut my own out of full size sheets of rubber gasket I got at Ace Hardware store. I got the white gasket color since my car is white, cut and trimmed them and installed to protect the chrome from scratching the valence :thumbsup:

Click, that's more of what I'm looking for. some type of gasket to protected the metal and to keep the water from going inside the rear valance.

any major body shop or auto paint store should have bulk sheets of gasket material, if not, Ace, Home Depot etc should. Cut out like a cookie cutter and test fit, trim and then bolt in :) I also put small rubber gaskets under the bumper bolts in all places and the verticle bumper supports.

i used strip caulking