Ineed to replace rockers and whole back half i have the frame sheet can i do a good job without a jig?

sure, piece of cake.. lot's of fun.. lot's of measuring.. lot's of Dynacorn sheetmetal..
a jig makes things much easier, and several TC members have made some very nice / basic jigs.
I just did a lot of clamping, and measuring, and tac-welding and re-measuring.

WE did it with jack stands and then went to a basic square tube dolly. Just do one component at a time. Measure, measure, measure. And take a lot of pics, print them out, and record the measurements on them, it's easier.
Good Luck,

Holy crap Tony, a mortal man would turn and run away. What stage are you at now ?

Do any of you have a good pic of a jig On and of the car? So I can make one for doing my Z10
Thanx,
Kevin:thumbsup:

Look at the pics on this site they mite help you get started.
Bob
http://www.musclecarmetal.com/refurb.htm