Welcome To Team Camaro Tech
First Generation Camaro Info and Tech - 1967-1969
Generation Specific Forums
All Generations
Team Camaro
Premium Plus Members Only
Marketplace
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Latest Posts
-
Has anyone found a source for a good fitting /original looking firewall insulation pad? I see that Heartbeat City Camaro is advertising a new pad available soon. I replaced my original a couple years ago, and while I can live with the neoprene cover instead of the original cardboard, the fit...8 replies 181 views
-
Hi People, Anyone fitted a K&N Filter to the end of the Cowl induction scoop (by windshield). BBC engine would then have a plate to seal to the underside of the hood. Carb would be open in the cavity (no filter here) Keen to see some pics what others have done. Thanks13 replies 513 views
-
Most everyone’s probably aware from my other posts that I’m working thru new engine install, a bellhousing indexing exercise, etc. And a question comes to mind; PO installed red poly type mounts for both engine and transmission, is there a significant difference in ride quality (e.g. smoother...11 replies 164 views
-
Didn't want to hijack another thread, so asking here. To be sure there is only one oil pressure port on a 74 casting #3970014 block, correct? Drivers side upper rear. Asking because using mechanical SW gage and with crossram this is the only fitting that clears the drivers side torque box...17 replies 552 views
-
Anyone used DOT 5 silicone on a new system. Factory front disc's and rear drums. All factory replacement parts (new). Any issues or complaints??? I have used before on another restoration and liked because of the no paint damage from an unnoticed leak. Thx2 replies 51 views