![]() |
|
Camaro Parts at SS396.com GROUND UP & SS396.com Official Sponsor of Team Camaro |
|
||
| Team Camaro Tech Current Topic: Largest Exhaust pipe through cross brace? | ||
Registered users (free) do not see these large ads 
| Convertibles Convertible Q&A's |
![]() |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
|
|||
|
|||
|
What's the largest diameter pipe that can fit through the cross brace on a 69 convertible?
__________________
69 Pace Car and 69 Hard top |
|
#2
|
|||
|
|||
|
I have a 67 vert. and I went with the 2 1/2 inch. I had to space the x-brace out to make it clear.
__________________
Brett |
|
#3
|
|||
|
|||
|
believe hotchkis makes one that will take 3 inch
|
|
#4
|
|||
|
|||
|
I saw that hotchkis extention - but was thinking it would put the brace a bit lower to the ground than I want - this z11 is low to the ground to start with - didn't want to drag things while driving - guess I could have an exhaust shop roll some flats in a 3 inch pipe to fit through there?
__________________
69 Pace Car and 69 Hard top |
|
#5
|
|||
|
|||
|
The Hotchkis brace is not going to drag unless you are dragging a whole bunch of other stuff as well. It does not really stick down any further than the subframe.
|
|
#6
|
||||
|
||||
|
I was running a 2/12" Flowmaster, I have been told my Hotchkis brace will clear a 3", I think though this time I'm going to use a retangular exhaust to clear the brace and get it back to where it goes over the axle and go back to 3" The LS7 needs to breath.
__________________
69 RS/SS vert tourer, LS7, T56, Baer, Hydrooost, GW, etc, etc, Needs more cowbell!!! |
|
#7
|
|||
|
|||
|
Quote:
I haven't seen rectangular tubing - seen oval - where do you get that and how's it expected to compare to round for flow?
__________________
69 Pace Car and 69 Hard top |
|
#8
|
|||
|
|||
|
I have the Hotchkis X brace with the TVS and I have plenty of room. Clearance off the ground and I have a 2 1/2' flowmaster kit with room enough room to go to 3" if needed.
__________________
67 Vert SS/RS 350 4 SP |
|
#9
|
|||
|
|||
|
I have a 3 inch magnaflow with the Hotchkis X brace. I had to build a 3/16's spacer to get it to fit. My Hooker headers flange are way lower then the brace.
__________________
67 (true RS) convertible 496...690hp Tremec TKO600 E.T's soon I hope! |
|
#10
|
|||
|
|||
|
Greetings from Arizona
My 69 Conv has 2.5 with stock brace going to single flowmaster behind diff. this car sits very low front 22.5 to wheel wells has 396 front springs/350 crate motor. wanted single muffler fo keep mufflers off ground and it can hardly seen sounds good Jay |
|
|
|
|
![]() |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|