Camaro Parts at SS396.com
GROUND UP & SS396.com
Official Sponsor of Team Camaro
|
|
Camaro Parts at SS396.com GROUND UP & SS396.com Official Sponsor of Team Camaro |
|
|
|
| Team Camaro Tech Current Topic: Cluthch Pivot Ball Location on Small Block | ||
Registered users (free) do not see these large ads | Tech 2000 Our previous General Forum Replies ONLY - no new topics. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
Nov 22nd, 99, 10:25 AM
|
|||
|
|||
Need to drill and tap my 400 sb for the clutch pivot ball. There are two undrilled/untapped bosses on the side of this engine. One is above the oil filter and the other is in front of this location by 3-5 inches. Which is the proper location for a small block in a '69 chassis?
|
|
#3
Nov 26th, 99, 05:22 PM
|
|||
|
|||
|
A picture is worth a ....
Since I've got the clutch out today, maybe a picture of the back of my 67 w/327 might help? http://www.surfari.net/~scottmoo/327nclut.jpg See that shinny lever shaft a few inches above the filter and about an inch to the left. That be it. The pivot looks to be indented about 1 1/4" from the back of the block. Regards
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
