[HOTROD69CAMARO]

I have a 330hp crate motor with vortec heads and I've swapped the cam and instsalled a comp xe262h and holley 750cfm vac secondaries. Would any of you guys with the dyno program and tell me if the cam bumped it up according to the computor. Thanks.

------------------
Black 69 camaro

[This message has been edited by HOTROD69CAMARO (edited 08-09-2001).]

[67RS502]

Just guessing, but I think it can make 400hp 400+tq with an RPM intake, a 1" spacer and 1 3/4" headers. Just guessing, sorry.


------------------
67RS STREET CAR, 502 PUMPGAS, HYD. ROLLER, TH350 w/ATI 10" 12-BOLT w/373 - 10.92@125.2 ON MOTOR, ET-STREETs w/MUFFLERS

[HOTROD69CAMARO]

It has 1 3/4 primary headers and is advertised at 330ft/lbs of torque. I dont have the dyno program and was just looking for anyone that has it to run the numbers. Thanks Mike.

------------------
Black 69 camaro

[czar]

hey hotrod69,

chp says the cam swap put your 350HO in the 390HPish backet w/262xe....and in the 400HPish bracket w/268xe.

there are dealers that sell the motors w/xe cams....they'll sell ya the dyno slip that verifies chp's claim....so, hope that answers your post...

have fun w/it!

[This message has been edited by czar (edited 08-09-2001).]

[HOTROD69CAMARO]

Thanks guys.I'll have the car to the chassis dyno soon. We'll see what it puts to the ground.60 HP seem awful generous with just a cam swap.The comp cam numbers arent that much different than what it had from GM. But we shall see.

------------------
Black 69 camaro

[This message has been edited by HOTROD69CAMARO (edited 08-10-2001).]