Camaro Parts at SS396.com
GROUND UP & SS396.com
Official Sponsor of Team Camaro
|
Auto Insurance |
|
|
Camaro Parts at SS396.com GROUND UP & SS396.com Official Sponsor of Team Camaro |
|
|
|
|
| Team Camaro Tech Current Topic: Pulley help needed asap please | ||
Registered users (free) do not see these large ads | Engine General Engine Discussion. |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
May 18th, 12, 02:36 PM
|
|||
|
|||
Pulley help needed asap please
Guys -
I have been searching the archives trying to find the right pulley for my motor swap. I need to come up with a two grove crankshaft pulley for a big block with a long water pump. Everything I find on the Camaro pulley websites cited here is for a short pump. Do you guys know what the proper diamater for a long pump on a big block would be? I have a found a couple on Summitt/Jegs but they have different diameters and I am stumped. Any help would be greatly appreciated.
__________________
68 Camaro RS/SS 350/300 4-Speed 
|
| Sponsored Links | ||
Advertisement | ||
|
#2
May 18th, 12, 04:33 PM
|
|||
|
|||
Re: Pulley help needed asap please
The only year of the 1st gens, that used long waterpumps was the '69.
 http://www.rickscamaros.com/camaro-c...1969-1970.html It is cheaper to buy a 3 groove. (not a deep groove) http://www.rickscamaros.com/camaro-h...1969-1975.html 3 - groove Chrome # 3172 7.74" diameter $34.95 http://www.hotrodchrome.com/pulleys.html
__________________
69 Camaro -originally a LM1 car. 327, Edelbrock E-streets, hooker, DUI performance distributors, ultradyne cam, stewart, TRW etc. Vintage Air, AGR steering, Corbeau GTSII seats, 700R4 TPI transmission, 12-bolt w/Eaton 4.11:1 Last edited by TJS69; May 18th, 12 at 05:05 PM.
|
| Sponsored Links | |
Advertisement | |
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Linear Mode
