[bdcole_51]

Hey guys,I am getting ready to put full length floor pans in my 68 and I noticed that a lot of the welds that some of these bodymen do are a little rough.My question is ,are there any products out there,such as some type of filler to smooth out the rough welds that will not burn or melt with the heat from the headers and pipes.Any help would be appreciated Thanks Camaro BOB

[RickD]

I ground off the worst of the 'weld buggers' and used POR Patch by POR15.

------------------
Rick Dorion
69 RS Conv,355,Autogear M22,4.10's and I don't worry about stone chips ( yet ).

[Winch]

Hmmm... floor pan dressing: corn bread, egg, celery, sage. If your headers are close they'll bake it just right