Heater plenum - Team Camaro Tech
Tech 2000 Our previous General Forum
Replies ONLY - no new topics.

LinkBack Thread Tools Display Modes
post #1 of 2 (permalink) Old Nov 12th, 00, 11:43 AM Thread Starter
Tech Team
Join Date: Nov 2000
Location: Rockford Michigan
Posts: 42

I am trying to replace the heating plenum door seals on my 67. The soft seal kit says to remove the crank arms for access to the doors. How is this done? The pivots look spot welded or pressed to the door hinges. Has anyone attempted this?
sschuell is offline  
Sponsored Links
post #2 of 2 (permalink) Old Nov 12th, 00, 12:16 PM
Senior Tech
Join Date: Apr 2000
Location: Huntington Beach
Posts: 120

The bottom side of the crank is just a pin with a head on it that pulls out, then you take a pin punch and drive the hinge pin out from the bottom up. Its not easy but I have done it and thats how its done.
Good luck, AL.
302XRAM is offline  
Sponsored Links

Quick Reply

Register Now

In order to be able to post messages on the Team Camaro Tech forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address.
NOTE we receive a lot of registrations with bad email addresses. IF you do not receive your confirmation email you will not be able to post. contact support and we will try and help.
Be sure you enter a valid email address and check your spam folder as well.

Email Address:


Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode

Posting Rules  
You may not post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

For the best viewing experience please update your browser to Google Chrome